Drive Roller
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 213.
2. Remove the Left Cover
See Cover, Left on page 215.
3. Remove the Right Connector Cover
See Connector Cover, Right on page 224.
4. Remove the Left Connector Cover
See Connector Cover, Left on page 225.
5. Remove the Service Station
See Service Station on page 233.
6. Remove the Ink Supply Station
See Ink Supply Station (ISS) on page 297.
7. Remove the Media-Axis Motor
See Media-Axis Motor on page 313.
8. Remove the Encoder Disc and Sensor
See Encoder Disc and Sensor on page 386.
9. Remove two T-10 screws that secure the Drive Roller Gear.
10. Remove the Drive Roller Gear from the printer.
394 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...