SE 59.2:00
Cause: An unsupported or reused part has been installed
Solution: Install only new parts recommended by HP for this printer.
SE 59.4:10
Cause: Cryptoasic communication error
Solution: Replace the SRK and Trailing Cable Service Kit.
SE 60.1:11
Cause: Initialization error
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord.
●
Check that the printer is properly connected in all other respects. In particular, check that the tag cable
is well connected to the ISS Top PCA, and the ISS Top PCA is well connected to the PrintMech PCA.
●
Reconnect the power cord and turn on the printer.
●
If the error persists, contact HP.
SE 60.2:17
Cause: Initialization error
Solution: Contact HP.
SE 61:01
Cause: The file format is incorrect and the printer cannot process the job
Solution: Try the following.
●
Turn off the printer using the switch at the rear, and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check the graphic language setting of the printer (see the User’s Guide).
SE 61:04.1
Cause: The PostScript fonts are missing
Solution: Perform a full firmware update.
SE 61:04.2
Cause: PostScript unknown Paper ID
Solution: Perform a full firmware update.
SE 61:08
Cause: The paper type specified in the file is incorrect and the printer cannot process the job
Solution: Try the following.
62 Chapter 3 System error codes ENWW
To Next Page
Loading...