HP Designjet T7200

7. Completely unroute the Primer Valve cable from the Service Station.
Service Station
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 213.
2. Remove the Primer Assembly
See Primer Assembly on page 228.
3. Remove the Primer Valves
See Primer Valves on page 230.
4. Remove the Drop Detector
See Drop Detector on page 243.
5. Remove the Right Connector Cover
See Connector Cover, Right on page 224.
6. Remove the Maintenance Cartridge
See the User’s Guide.
7. Remove the Right Rear Trim
See Rear Trim, Right on page 332.
8. Disconnect the cable from the Maintenance Cartridge Door Switch.
ENWW Disassembly order 233