HP Designjet T7200

SE 35:10
Cause: Rear Door sensor error detected
Solution: Try the following:
●
Check that the Left and Right Rear Door Sensor cables are not damaged and are connected correctly to
the Interconnect PCA.
●
Replace the Rear Door
Rear Door on page 333.
SE 37:03
Cause: ARSS motor shutdown
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Replace the Rear Door
Rear Door on page 333.
SE 38:03
Cause: Stacker communication protocol error
Solution: Try the following:
●
Restart the printer.
●
Check that the cable between the stacker and the printer is undamaged and correctly connected.
●
Update the stacker firmware.
●
Replace the Stacker Electronics PCA
Electronics PCA on page 429.
SE 38.0:01
Cause: Paper jam detected in stacker; buffer sensor activated
Solution: Try the following:
●
Remove any paper jammed in the printer or stacker, and restart the printer.
●
Perform the Paper Drive test
Paper Drive test on page 84.
SE 38.0:10
Cause: Paper jam detected in stacker; buffer sensor not activated
Solution: Try the following:
●
Remove any paper jammed in the printer or stacker, and restart the printer.
●
Perform the Paper Drive test
Paper Drive test on page 84.
SE 38.1:01
Cause: Stacker communication error
Solution: Try the following:
52 Chapter 3 System error codes ENWW