8
th
TEMP_TOO_LOW
18
th
FULL_DUMMY
9
th
BAD_ACUMEN_INFO
19
th
END_OF_LIFE
10
th
NO_PEN
20
th
OUT_OF_WARRANTY
The binary number needs to be read from right to left so that the 1
st
bit corresponds to the right one of the
binary number. For example, the error code 4099 is converted to binary number 10000000000011. So using
the table above, the error code means “FAILS_LOGICAL_V”, “FAILS_CONTINUITY” and “MISMATCH”.
Carriage Interconnect Wiper
Whenever you replace the Printhead, check the empty slots to see if they need cleaning. In extreme
circumstances, when a Printhead is inserted, it is possible that the printer will not recognize it due to the
build-up of ink on the electrical connection between the Printhead and the Carriage Assembly.
The Carriage Interconnect Wiper is available as an accessory in a separate package. The package also
contains replacement sponges and an instruction sheet. This tool should be used for cleaning the electrical
interconnects of both the Carriage Assembly and the Printhead.
If the front panel displays the message Reseat or Replace next to the offending printhead, try cleaning the
flex circuits of the Carriage and the Printheads.
CAUTION: Do not touch, wipe or attempt to clean the printhead nozzles. This can damage the printhead and
reduce print quality.
Warranty information for ink supplies
●
Ink Cartridge
●
Printheads
●
Printhead Service Code
Ink Cartridge
The warranty for an Ink Cartridge ends when one of the following occurs:
●
30 months have passed since the date of manufacture.
or
●
The Ink Cartridge has supplied all the ink that it is advertised as containing.
or
●
The customer confirms that non-HP ink has been used in empty override mode.
The actual end of warranty date is printed on the supply label.
ENWW Carriage Interconnect Wiper 79
To Next Page
Loading...