Carriage Flex Cables
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 213.
2. Remove the Front Panel
See Front Panel on page 226.
3. Disconnect the Trailing Cable from the Carriage PCA.
4. Press the two side of the Carriage PCA Cover and unclip from the Carriage Assembly.
5. Use a flat bladed screwdriver to release the all the clips, securing the Carriage Flex Cables to the
Carriage Assembly, by pulling upwards.
280 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...