8. The front panel asks you to remove the paper. If you loaded a roll earlier, unload it manually. Press OK
when done.
9. Some further tests are performed, and the results displayed.
10. When the whole test has been completed successfully, the following message is displayed. Press OK to
restart the printer.
Electronics Module test
The purpose of this test is to diagnose a failure in the operation of the Formatter.
1. In the Service Tests submenu, scroll to Electronics Module Test and press OK.
2. A message appears on the Front Panel asking whether you would like to check the Formatter. Press OK
to continue with the test, or Cancel to exit.
3. The front panel displays the amount of memory installed. “Real memory size” is the real size detected,
and “Total memory size” shows the rounded memory size. Press OK to continue.
4. The front panel displays the name, type and size of all the partitions on the Hard Disk. Press OK to
continue.
86 Chapter 5 Service tests and utilities ENWW
To Next Page
Loading...