3. The printer performs some movement tests. The drive roller may move repeatedly during the tests. At
the end the following message will be shown if the tests succeeded:
4. Depending on the results of the tests, the front panel may display one of the following messages.
●
The printer was unable to make the test movements correctly.
●
You are asked to load paper manually, and press OK.
NOTE: Please ignore references to the lever. You may need to open and close the rear door.
●
The printer tries the movements again.
5. The printer calibrates the analog encoder.
6. The calibration results are displayed.
Acceptable values are:
●
Gain: between 0 and 5
●
DGain: between 0 and 15
●
Offset: between -80 and 80
If the results are acceptable, press OK. If the results are unacceptable, then press Cancel.
7. The printer performs the encoder homing test.
ENWW Entering the Service Tests menu 85
To Next Page
Loading...