HP Designjet T7200

●
Check that the ISS to Cartridge cable is not damaged and is correctly connected to the Ink Supply Tubes
PCA.
●
Replace the ISS to Cartridge cable
ISS to Cartridge Cables on page 295.
SE 27.1:01
Cause: Calibration failed to due to poor performance of the Yellow Printhead in slot 1
Solution: This may impact your print quality. If it becomes unacceptable in the future, clean all printheads
and check their status.
SE 27.2:01
Cause: Calibration failed to due to poor performance of the Yellow Printhead in slot 2
Solution: This may impact your print quality. If it becomes unacceptable in the future, clean all printheads
and check their status.
SE 27.3:01
Cause: Calibration failed to due to poor performance of the Magenta/Cyan Printhead in slot 3
Solution: This may impact your print quality. If it becomes unacceptable in the future, clean all printheads
and check their status.
SE 27.4:01
Cause: Calibration failed to due to poor performance of the Magenta/Cyan Printhead in slot 4
Solution: This may impact your print quality. If it becomes unacceptable in the future, clean all printheads
and check their status.
SE 27.5:01
Cause: Calibration failed to due to poor performance of the Matte Black Printhead in slot 5.
Solution: This may impact your print quality. If it becomes unacceptable in the future, clean all printheads
and check their status.
SE 27.6:01
Cause: Calibration failed to due to poor performance of the Matte Black Printhead in slot 6.
Solution: This may impact your print quality. If it becomes unacceptable in the future, clean all printheads
and check their status.
SE 27.7:01
Cause: Calibration failed to due to poor performance of the Gray/Dark Gray Printhead in slot 7.
Solution: This may impact your print quality. If it becomes unacceptable in the future, clean all printheads
and check their status.
SE 27.8:01
Cause: Calibration failed to due to poor performance of the Gray/Dark Gray Printhead in slot 8.
Solution: This may impact your print quality. If it becomes unacceptable in the future, clean all printheads
and check their status.
48 Chapter 3 System error codes ENWW