●
Media Specific Calibrations (performed by the User).
General calibrations
●
Printhead Alignment relates to the Printhead Alignment which changes to ‘pending’ when a Printhead
is replaced and the Printhead Alignment has not been performed.
NOTE: When a component is replaced, the corresponding calibration is NOT automatically set to ‘NOT
DONE‘. This is because the printer does not know that there is a new part installed.
●
Drop Detector relates to the Drop Detector or Service Station calibration.
●
Line Sensor relates to the Line Sensor Calibration.
Media-specific calibrations
This section shows the following for each type of media:
●
Media Name
●
Color
●
Paper Advance
Connectivity configuration
This page contains full details of the current configuration of the printer.
ENWW How to interpret the Service Information Pages 23
To Next Page
Loading...