HP Designjet T7200

●
Check that the Safety Temperature Sensor is correctly installed.
●
Replace the Safety Temperature Sensor
Safety Temperature Sensor on page 418.
SE 38.2:11
Cause: Stacker temperature too low
Solution: Try the following:
●
Check that the Safety Temperature Sensor is correctly installed.
●
Replace the Safety Temperature Sensor
Safety Temperature Sensor on page 418.
SE 38.3:11
Cause: Stacker heating element overhead switch off
Solution: Try the following:
●
Turn off the stacker and leave it to cool down for 10 minutes.
●
Check the distance of the Safety Temperature Sensor from the Heater Roller.
●
Check the temperature of the Heater Roller.
SE 38.4:10
Cause: Stacker heating element failure
Solution: Try the following:
●
Turn the power off from the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Heating Lamp is correctly installed.
●
Replace the Heating Lamp
Heating Lamp on page 436.
SE 38.5:01
Cause: Stacker motor overload
Solution: Try the following:
●
Check that the Drive Motor is not blocked by turning the stacker off and on.
●
Check that the Stacker Transport Belt can turn freely.
●
Check for any debris in the paper path.
●
Check that all the connections to the Drive Motor are correct.
●
Replace the Drive Motor
Drive Motor on page 414.
SE 38.5:10
Cause: Stacker abnormal motor condition
Solution: Try the following:
54 Chapter 3 System error codes ENWW