6. Remove one T-15 screw from the right-hand lever.
7. Remove the Smart Roll-loading System Door.
Carriage
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 213.
2. Remove the Front Panel
See Front Panel on page 226.
3. Remove the Primer Assembly
See Primer Assembly on page 228.
4. Remove the Left Cover
See Cover, Left on page 215.
5. Remove the Encoder Strip
See Encoder Strip and Encoder Sensor on page 282.
270 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...