TIP: When you first start a printer with a new Hard Disk Drive, encrypted or not, it may display an error
message (79:04). Turn off the printer and restart. The printer should start normally.
CAUTION: Turning off the printer during the start-up procedure with a new Formatter and Hard Disk Drive
may corrupt the BIOS password, leaving the system useless with no ability to restart.
TIP: After installing a new Formatter board in a Rev B printer, reset the password.
Hard Disk Drive (HDD)
Removal
WARNING! Switch off the printer and remove the power cable.
NOTE: You must never replace both the Hard Disk Drive and the Ink Supply Tubes and Trailing Cable at the
same time. If both parts need to replaced, you must first replace one part and then power on the printer until
it initializes completely. Then you can power off the printer and replace the other part.
1. Remove the Jetdirect Card (if installed).
2. Remove three T-20 screws that secure the Formatter cover.
ENWW Disassembly order 363
To Next Page
Loading...