When the new aerosol Fan and Filter have been installed, it is important to check that the fan is funcioning
correctly, otherwise the printer will suffer from Aerosol spray. To check that the fan is working correctly,
make sure the printer is printing and check for airflow in the area of the rear of the Service Station.
Drop Detector
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 213.
2. Disconnect the Drop Detector Cable from the Service Station Cable.
3. Release the Drop Detector Cable from the Service Station.
ENWW Disassembly order 243
To Next Page
Loading...