WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 213.
2. Remove the PW Cover
See PW Cover on page 331.
3. Remove the Right Connector Cover
See Connector Cover, Right on page 224.
4. Remove the Service Station
See Service Station on page 233.
5. Remove four T-15 screws (Type G) that secure the Aerosol Fan to the Service Station.
6. Remove the Aerosol Fan from the Service Station.
7. If necessary, remove the Aerosol Fan Filter from the Aerosol Fan.
Installing
242 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...