SE 24:10
Cause: A broken bag has been detected in one of the Ink Cartridges
Solution: Try the following.
●
Press Down + Cancel to see which cartridges have a broken bag. Remove the affected cartridges, shake
each one three times within 2 seconds through a distance of about 40 cm, and check whether the
cartridge air tower is contaminated with ink. If at least one cartridge is contaminated, replace the Ink
Supply Tubes and Trailing Cable
Ink Supply Tubes and Trailing Cable on page 286.
NOTE: If the Ink Supply Tubes are to be replaced, the Ink Cartridges need to be checked beforehand to
see if they are capable of purging the new tubes. If they are not, new Ink Cartridges must also be sent
with the parts to be replaced. To check the Ink Cartridges, see
Check ink supplies on page 90.
●
If no cartridge seems contaminated, follow the broken bag recovery procedure for more information
Recover broken bag on page 92.
SE 24:11
Cause: PrintMech to ISS Top cable does not seem to be connected
Solution: Try the following.
●
Check that the PrintMech to ISS Top cable cable is not damaged.
●
Check that the PrintMech to ISS Top cable is correctly connected to the PrintMech PCA and ISS Top PCA.
●
Replace the PrintMech to ISS Top cable (which is included in the Electronics Module Cable Kit).
SE 24.1:11
Cause: ISS Top to ISS Bottom cable does not seem to be connected
Solution: Try the following.
●
Check that the ISS Top to ISS Bottom cable cable is not damaged.
●
Check that the ISS Top to ISS Bottom cable is correctly connected to the ISS Top PCA and ISS Bottom
PCA.
●
Replace the ISS Top to ISS Bottom cable (which is included in the Electronics Module Cable Kit).
SE 26.0:01
Cause: Bad contact detected in ISS slot 0 floater
Solution: Try the following operations on the Yellow Ink Cartridge.
●
Remove the Ink Cartridge and reinstall it into the printer.
●
Replace the Ink Cartridge.
●
Check that the ISS to Cartridge cable is not damaged and is correctly connected to the Ink Supply Tubes
PCA.
●
Replace the ISS to Cartridge cable
ISS to Cartridge Cables on page 295.
SE 26.1:01
Cause: Bad contact detected in ISS slot 1 floater
Solution: Try the following operations on the Cyan Cartridge.
46 Chapter 3 System error codes ENWW
To Next Page
Loading...