SE 53:10
Cause: Media Sensor error
Solution: Try the following.
●
Check that the Media Sensor cable is not damaged and is connected correctly to the Interconnect PCA.
●
Replace the Media Sensor
Media Sensor on page 324.
SE 53.1:11
Cause: Media Sensor cable does not seem to be connected
Solution: Try the following.
●
Check that the Media Sensor cable is not damaged.
●
Check that the Media Sensor cable is correctly connected to the Interconnect PCA.
SE 55:10
Cause: Line Sensor communication failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Replace the Line Sensor
Line Sensor Assembly on page 285.
SE 56:01
Cause: Incorrect readings from paper encoder
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Perform Paper Drive diagnostics.
●
Replace the Encoder Disc and Sensor
Encoder Disc and Sensor on page 386.
SE 56:10
Cause: Paper Encoder calibration failed
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Perform Paper Drive diagnostics.
●
Replace the Encoder Disc and Sensor
Encoder Disc and Sensor on page 386.
SE 59.1:09
Cause: Two electrical parts have been replaced at the same time
Solution: Replace one part at a time, and restart the printer before replacing another.
ENWW Continuable and non-continuable error codes 61
To Next Page
Loading...