HP Designjet T7200

Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
If the printer is a Rev A, replace the Formatter
Formatter on page 360.
●
If the printer is a Rev B, replace the Formatter and the Hard Disk Drive
Hard Disk Drive (HDD)
on page 363.
SE 06:03
Cause: Main NVM communication failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
If the printer is a Rev A, replace the Hard Disk Drive
Hard Disk Drive (HDD) on page 363.
●
If the printer is a Rev B, replace the Hard Disk Drive and the Formatter
Formatter on page 360.
SE 06:10
Cause: Main NVM communication failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
If the printer is a Rev A, replace the Hard Disk Drive
Hard Disk Drive (HDD) on page 363.
●
If the printer is a Rev B, replace the Hard Disk Drive and the Formatter
Formatter on page 360.
SE 08:11
Cause: Front Panel communication failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
See
What to do if the front panel is blank on page 38.
SE 11:10
Cause: Trailing Cable does not seem to be connected
Solution: Try the following.
●
Check that the Trailing Cable is not damaged.
●
Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA and Main PCA.
●
Replace the Ink Supply Tubes and Trailing Cable.
NOTE: If the Ink Supply Tubes are to be replaced, the Ink Cartridges need to be checked beforehand to
see if they are capable of purging the new tubes. If they are not, new Ink Cartridges must also be sent
with the parts to be replaced. To check the Ink Cartridges, see
Check ink supplies on page 90.
ENWW Continuable and non-continuable error codes 43