This print helps you to check any alignment problems of the printer.
You can use it to measure the alignment error with an accuracy of one dot row.
The print is split into three areas. The first two are the same print, printed at different speeds: 40 and 60 ips
to check most of the printhead alignment. The print modes associated with these speeds are shown in the
following table:
PM by Paper Category
ips
Paper Type Category Quality Setting
Plain or Technical: Bond, Recycled, Matte Film, Natural
Tracing Paper, Translucent Bond and so on
Econofast
60
Fast
Normal
30
Best
Best, Extra passes 40
Coated Paper
Econofast
60
Fast
Normal
40Best
Best, Extra passes
Heavyweight Coated Paper, Glossy Paper, Backlit,
Polypropylene
All 40
The third part is to check the same color staggered printhead overlap.
148 Chapter 7 Print quality ENWW
To Next Page
Loading...