CAUTION: You MUST NEVER replace both the Hard Disk Drive and the Ink Supply Tubes and Trailing Cable at
the same time. If both parts need to replaced, you MUST first replace one part and then power ON the printer
until it completely initializes. Then you can power OFF the printer and replace the other part.
1. Remove the Right Cover See Cover, Right on page 213.
2. Remove the Left Cover
See Cover, Left on page 215.
3. Remove the Top Cover
See Cover, Top on page 219.
4. Remove the Right Connector Cover
See Connector Cover, Right on page 224.
5. Remove the Right Rear Trim
See Rear Trim, Right on page 332.
6. Remove the Right Smart Roll-loading System Cover
See Smart Roll-loading System Cover, Right
on page 245.
7. Disconnect the Trailing Cable from the Interconnect PCA and the Main PCA.
8. Unclip the Trailing Cable ferrites from the left side of the Electronic Module, and pass the cable through
the sideplate.
ENWW Disassembly order 287
To Next Page
Loading...