6. Slide the Hard Disk Drive upwards and remove from the printer.
NOTE: It is not necessary to remove the screws securing the HDD inside the metal casing.
Installation (Rev A printers)
After installing a new HDD, make sure you perform the following user calibrations:
●
Printhead Alignment
●
Paper Advance Calibration
●
Color Calibration
Installation (Rev B printers)
1. Install the new HDD assembly and T-10 screw.
2. Connect the SATA cable to the Formatter SATA connector and the other end to the HDD SATA connector.
3. Connect the SATA power cable to the HDD power cable from the PSU to the SATA power connector.
4. Identify the HDD Protect Jumper.
ENWW Disassembly order 365
To Next Page
Loading...