Huawei Quidway S3900 Series - Voice Vlan Configuration Displaying; Voice Vlan Configuration Example (Automatic Mode)

Operation Manual – Voice VLAN
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Voice VLAN Configuration
Huawei Technologies Proprietary
1-8
1.3 Voice VLAN Configuration Displaying
After the above configurations, you can execute the display command in any view to
view the running status and verify the configuration effect.
Table 1-5 Display configurations of a Voice VLAN
Operation Command Description
Display the
information about
ports on which
Voice VLAN
configuration fails
display voice vlan error-info
Display the voice
VLAN
configuration
status
display voice vlan status
Display the
currently valid OUI
addresses
display voice vlan oui
Display the ports
operating in the
current voice
VLAN
display vlan vlan-id
You can execute the
display command in any
view.
1.4 Voice VLAN Configuration Example
1.4.1 Voice VLAN Configuration Example (Automatic Mode)
I. Network requirements
z Create VLAN 2 and configure it as a voice VLAN.
z Configure GigabitEthernet1/0/1 port as a Trunk port, with VLAN 6 as the default
port.
z Ethernet1/0/1 port can be added to/removed from the voice VLAN automatically
according to the type of the data stream that reaches the port.
II. Configuration procedure
# Create VLAN 2.
<Quidway> system-view
[Quidway] vlan 2
# Configure Ethernet1/0/1 port to be a Trunk port, with VLAN 6 as the default VLAN.
[Quidway] interface Ethernet1/0/1
[Quidway-Ethernet1/0/1] port link-type trunk
[Quidway-Ethernet1/0/3] port trunk pvid vlan 6