Huawei Quidway S3900 Series User Manual

Operation Manual – MSTP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 MSTP Configuration
Huawei Technologies Proprietary
1-25
Operation Command Description
Disable MSTP on the
port
stp disable
Optional
By default, MSTP is
enabled on all ports after
you enable MSTP in system
view.
To enable a switch to
operate more flexibly, you
can disable MSTP on
specific ports. As
MSTP-disabled ports do not
participate in spanning tree
generation, this operation
saves CPU resources.
Other MSTP-related settings can take effect only after MSTP is enabled on the switch.
II. Configuration example
# Enable MSTP on the switch and disable MSTP on Ethernet1/0/1 port.
z Configure in system view.
<Quidway> system-view
[Quidway] stp enable
[Quidway] stp interface ethernet1/0/1 disable
z Configure in Ethernet port view.
<Quidway> system-view
[Quidway] stp enable
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] stp disable
1.3 Leaf Node Configuration
Table 1-21 lists MSTP-related configurations about leaf nodes.
Table 1-21 Leaf node configuration
Operation Remarks Related section
MSTP configuration
Required
To prevent network
topology jitter caused by
other related
configurations, you are
recommended to enable
MSTP after performing
other configurations.
Section
1.2.14 “MSTP
Configuration”
MST region
configuration
Required
Section 1.2.2 “MST Region
Configuration”

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English