Operation Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
Huawei Technologies Proprietary
1-28
Operation Command Description
Set the maximum
number of
transmission
attempts of
RADIUS requests
retry retry-times
Optional
By default, the system tries three
times to transmit a RADIUS request.
1.4.6 Configuring the Supported RADIUS Server Type
Table 1-17 Configure the supported RADIUS server type
Operation Command Description
Enter system view
system-view
—
Create a RADIUS
scheme and enter
its view
radius scheme
radius-scheme-na
me
Required
By default, a RADIUS scheme named
"system" has already been created in
the system.
Specify the type of
RADIUS server
supported by the
switch
server-type
{ huawei |
standard }
Optional
1.4.7 Configuring the Status of RADIUS Servers
For the primary and secondary servers (authentication/authorization servers, or
accounting servers) in a RADIUS scheme:
When the switch fails to communicate with the primary server due to some server
trouble, the switch will actively exchange packets with the secondary server.
After the time the primary server keeps in the block state exceeds the time set with the
timer quiet command, the switch will try to communicate with the primary server again
when it receives a RADIUS request. If the primary server recovers, the switch
immediately restores the communication with the primary server instead of
communicating with the secondary server, and at the same time restores the status of
the primary server to the active state while keeping the status of the secondary server
unchanged.
When both the primary and secondary servers are in active or block state, the switch
sends packets only to the primary server.
Table 1-18 Set the status of RADIUS servers
Operation Command Description
Enter system view
system-view
—
To Next Page
Loading...
