Operation Manual – PoE & PoE Profile
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 2 PoE Profile Configuration
Huawei Technologies Proprietary
2-3
z When the apply poe-profile command is used to apply a PoE profile to a port, the
PoE profile is applied successfully only if one PoE feature in the PoE profile is
applied properly. When the display current-configuration command is used for
query, it is displayed that the PoE profile is applied properly to the port.
z If one or more features in the PoE profile are not applied properly on a port, the
switch will prompt explicitly which PoE features in the PoE profile are not applied
properly on which ports.
z The display current-configuration command can be used to query which PoE
profiles are applied to a port. However, the command cannot be used to query which
PoE features in a PoE profiles are applied successfully.
Caution:
z PoE profile configuration is a global configuration, and applies synchronously in the
IRF system.
z Combination of Unit creates a new Fabric. In the newly created Fabric, the PoE
profile configuration of the Unit with the smallest Unit ID number will become the
PoE profile configuration for the Fabric currently in use.
z Split of Fabric results in many new Fabrics. In each newly created Fabric, the PoE
profile configuration of each Unit remains the same as it was before the split.
2.3 Displaying PoE Profile Configuration
After the above configuration, execute the display command in any view to see the
running status of the PoE profile and verify the effect of the configuration by checking
the displayed information.
Table 2-2 Display the PoE profile configuration
Operation Command Description
Display the detailed
information about the PoE
profiles created on the
switch
display poe-profile
{ all-profile | interface
interface-type
interface-number | name
profile-name }
You can execute
the display
command in any
view
To Next Page
Loading...
Need help?
General