Huawei Quidway S3900 Series - Configuring Ntdp-Related Parameters; Enabling the Cluster Function

Operation Manual – Cluster
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Cluste
r
Huawei Technologies Proprietary
1-9
Operation Command Description
Enable NTDP
globally
ntdp enable
Required
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable NTDP for
the Ethernet port
ntdp enable
Required
1.2.5 Configuring NTDP-related Parameters
Table 1-6 Configure NTDP parameters
Operation Command Description
Enter system view
system-view
—
Configure the
range topology
information within
which is to be
collected
ntdp hop hop-value
Optional
By default, the hop range for
topology collection is 3 hops
Configure the hop
delay to forward
topology-collection
request packets
ntdp timer hop-delay time
Optional
By default, the delay of the
device is 200 ms
Configure the port
delay to forward
topology collection
request packets
ntdp timer port-delay time
Optional
By default, the port delay is 20
ms
Configure the
interval to collect
topology
information
ntdp timer
interval-in-minutes
Optional
By default, the interval of
topology collection is 1 minute
Quit system view.
quit
—
Start topology
information
collection
ntdp explore
Optional
1.2.6 Enabling the Cluster Function
Table 1-7 Enable the cluster function
Operation Command Description
Enter system view
system-view
—