Operation Manual - HWPing
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 HWPing Configurations
Huawei Technologies Proprietary
1-2
3) Number of test packets sent in a test
If this parameter is set to a number greater than one, the system sends the second test
packet once it receives a response to the first one, or when the test timer times out if it
receives no response after sending the first one, and so forth until the last test packet is
sent out. This parameter is equivalent to the –n keyword in the ping command.
4) Automatic test interval
This parameter is used to allow the system to automatically perform the same test at
regular intervals.
5) Test timeout time
Test timeout time is the time the system waits for an ECHO-RESPONSE packet after it
sends out an ECHO-REQUEST packet. If no ECHO-RESPONSE packet is received
within this time, this test is considered a failure. This parameter is similar to the -t
keyword in the ping command, but has a different unit (the -t keyword in the ping
command is in ms, while the timeout time in the HWPing command is in seconds).
1.2.2 Configuring HWPing
Table 1-1 Configure HWPing
Operation Command Description
Enter system view
system-view
—
Enable HWPing Client
hwping-agent
enable
Required
By default, HWPing
Client is disabled.
Create an HWPing test group
hwping
administrator-na
me test-tag
Required
By default, no HWPing
test group is configured.
Configure the
destination IP
address of the test
destination-ip
ip-address
Required
By default, no destination
IP address is configured.
Configure the type
of the test.
test-type type
Optional
By default, the test type is
ICMP.
Configure the
packet sending
times in each test.
count times
Optional
By default, the packet
sending times in each
test is 1.
Configure
the test
parameters
Configure the
automatic test
interval.
frequency
interval
Optional
By default, the automatic
test interval is zero, which
indicating no automatic
test will be performed.
To Next Page
Loading...
Need help?
General