Operation Manual – SNMP and RMON
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 SNMP Configuration
Huawei Technologies Proprietary
1-9
Operation Command Description
Display Trap list information
display snmp-agent
trap-list
Display the currently configured
community name
display snmp-agent
community [ read |
write ]
Display the currently configured MIB
view
display snmp-agent
mib-view [ exclude |
include | viewname
view-name ]
1.6 SNMP Configuration Example
1.6.1 SNMP Configuration Example
I. Network requirements
z An NMS and Switch A are connected through the Ethernet. The IP address of the
NMS is 10.10.10.1 and that of the VLAN interface on Switch A is 10.10.10.2.
z Perform the following configuration on Switch A: setting the community name and
access authority, administrator ID, contact and switch location, and enabling the
switch to sent trap packet.
II. Network diagram
Ethernet
NMS
10.10.10.1
10.10.10 .2
Ethernet
NMS
10.10.10.1
10.10.10 .2
Figure 1-2 Network diagram for SNMP
III. Network procedure
# Set the community name, group name and user.
<Quidway> system-view
[Quidway] snmp-agent
[Quidway] snmp-agent sys-info version all
[Quidway] snmp-agent community write public