Huawei Technologies Proprietary
1-14
Note:
z To view debug information of specific modules, you need to set the information type
as debug in the info-center source command, and enable debugging on
corresponding modules with the debugging command as well.
z To send information to remote SNMP workstation properly, related configurations
are required on both the switch and the SNMP workstation.
1.3 Displaying and Debugging Information Center
Configuration
After the above configurations, you can execute the display command in any view to
display the running status of the information center, and thus validate you
configurations. You can also execute the reset command in user view to clear the
information in the log buffer and trap buffer.
Table 1-13 Display and debug information center
Operation Command Description
Display information on
information channel
display channel [ channel-number |
channel-name ]
Display the operation
status of information
center, the configuration
of information channels,
the format of time stamp
and the information
output in case of fabric
display info-center [ unit unit-id ]
Display the status of log
buffer and the information
recorded in log buffer
display logbuffer [ unit unit-id ]
[ level severity | size buffersize ]* [ |
{ begin | exclude | include }
regular-expression ]
Display the summary
information recorded in
log buffer
display logbuffer summary [ level
severity ]
Display the status of trap
buffer and the information
recorded in trap buffer
display trapbuffer [ unit unit-id ]
[ size buffersize ]
The display
command can be
executed in any
view
Clear information
recorded in log buffer
reset logbuffer [ unit unit-id ]
Clear information
recorded in trap buffer
reset trapbuffer [ unit unit-id ]
The reset
command can be
executed in user
view
To Next Page
Loading...
Need help?
General