Huawei Quidway S3900 Series - Cluster Configuration Example; Basic Cluster Configuration Example

Operation Manual – Cluster
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Cluste
r
Huawei Technologies Proprietary
1-16
Operation Command Description
Display state and
statistics
information about a
cluster
display cluster
Display the
information about
the candidate
devices of a cluster
display cluster candidates
[ mac-address H-H-H |
verbose ]
Display the
information about
the cluster
members
display cluster members
[ member-num | verbose ]
Clear the NDP
statistics on a port
reset ndp statistics
[ interface port-list ]
—
1.6 Cluster Configuration Example
1.6.1 Basic Cluster Configuration Example
I. Network requirements
Three switches form a cluster, in which:
z The management device is an S900 series switch.
z The rest are member devices.
The S3900 switch manages the rest two member devices as the management device.
The detailed information about the cluster is as follows.
z The two member devices are connected to Ethernet1/0/2 and Ethernet1/0/3 ports
of the management device.
z The management device is connected to the external network through its
Ethernet1/0/1 port.
z Ethernet1/0/1 port of the management device belongs to VLAN2, whose interface
IP address is 163.172.55.1.
z All the devices in the cluster use the same FTP server and TFTP server.
z The FTP server and TFTP server share one IP address: 63.172.55.1.
z The SNMP site and log host share one IP address: 69.172.55.4.