Operation Manual – VRRP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 VRRP Configuration
Huawei Technologies Proprietary
1-8
Operation Command Description
Create a VLAN
vlan vlan-id
—
This operation creates the
VLAN to which the backup
group corresponds. The
vlan-id argument is the ID of
the VLAN.
Quit to system view
quit
—
Enter VLAN
interface view
interface vlan-interface
vlan-id
—
Configure a virtual
router IP address
vrrp vrid virtual-router-id
virtual-ip virtual-address
Optional
1.2.3 Configuring Backup Group-Related Parameters
Table 1-4 lists the operations to configure a switch in a backup group.
Table 1-4 Configure backup group-related parameters
Operation Command Description
Enter system view system-view —
Create a VLAN
vlan vlan-id
—
Quit to system view
quit
—
Enter VLAN
interface view
interface vlan-interface
valn-id
—
Configure the
priority of the
backup group
vrrp vrid virtual-router-id
priority priority
Optional
By default, the priority of a
backup group is 100.
Configure the
preemptive mode
and delay period
for the backup
group
vrrp vrid virtual-router-id
preempt-mode [ timer
delay delay-value ]
Optional
By default, a backup group
operates in the preemptive
mode.
Configure the
authentication type
and authentication
key
vrrp authentication-mode
authentication-type
authentication-key
Optional
By default, a backup group
does not authenticate.
Configure the
VRRP timer
vrrp vrid virtual-router-id
timer advertise
adver-interval
Optional
By default, the interval for the
master switch in a backup
group to send VRRP packets
is 1 second.