Huawei Technologies Proprietary
1-7
1.2 Management Device Configuration
1.2.1 Management Device Configuration Tasks
Table 1-2 Management device configuration tasks
Operation Description Related section
Enable NDP
globally and for
specific ports
Required
Section 1.2.2 Enabling NDP
Globally and for Specific Ports
Configure
NDP-related
parameters
Required
Section 1.2.3 Configuring
NDP-related Parameters
Enable NTDP
globally and for
specific ports
Required
Section 1.2.4 Enabling NTDP
Globally and for Specific Ports
Configure
NTDP-related
parameters
Required
Section
1.2.5 Configuring
NTDP-related Parameters
Enable the cluster
function
Required
Section 1.2.6 Enabling the
Cluster Function
Configure cluster
parameters
Required
Section 1.2.7 Configuring
Cluster Parameters
Configure
interaction for the
cluster
Required
Section 1.2.8 Configuring
Interaction for the Cluster
Configure NM
interface for the
cluster
Optional
Section 1.2.9 Configuring NM
Interface for the Cluster
Note:
To protect the unused sockets against malicious attacks and improve the switch
security, S3900 series Ethernet switches provide the following function:
z When the cluster function is enabled, socket UDP 40000 used by the cluster is
enabled;
z When the cluster function is disabled, socket UDP 40000 is disabled at the same
time.
This function is implemented on the command switch in the following scenarios:
z Use the build command or the auto-build command to create a cluster and enable
socket UDP 40000 used by the cluster at the same time.
z Use the undo build command or the undo cluster enable command to remove a
cluster and disable socket UDP 40000 at the same time.