Huawei Quidway S3900 Series - Configuring Traffic Statistics; Configuration Procedure of Traffic Statistics

Operation Manual - QoS&QoS Profile
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 QoS Configuration
Huawei Technologies Proprietary
1-25
1.11.2 Configuration Procedure
Table 1-16 Configure WRED parameters
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface
interface-type
interface-number
—
Configure WRED
parameters
wred queue-index
qstart probability
Required
The WRED function is disabled
by default
1.11.3 Configuration Example
z Configure WRED parameters for queue 2 on Ethernet 1/0/1. Packets are dropped
at random when the queue length is more than 64 packets, and the drop
probability is 20%.
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Ethernet 1/0/1
[Quidway-Ethernet1/0/1] wred 2 64 20
1.12 Configuring Traffic Statistics
Refer to 1.1.12 Traffic-based Traffic Statistics for the introduction to traffic statistics.
1.12.1 Configuration Prerequisites
z ACL rules used for traffic identifying are defined. Refer to the ACL module in the
book for defining ACL rules
z The ports that needs this configuration are specified
1.12.2 Configuration Procedure of Traffic Statistics
Table 1-17 Configure traffic statistics
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface
interface-type
interface-number
—