Huawei Quidway S3900 Series User Manual

Operation Manual – VLAN VPN
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 VLAN-VPN Configuration
Huawei Technologies Proprietary
1-3
Protocol type Value
IPX 0x8137
IS-IS 0x8000
LACP 0x8809
802.1x 0x888E
1.2 VLAN-VPN Configuration
1.2.1 Configuration Prerequisites
z GARP VLAN registration protocol (GVRP), GARP multicast registration protocol
(GMRP), intelligent resilient framework (IRF), neighbor topology discovery
protocol (NTDP), spanning tree protocol (STP) and 802.1x protocol are disabled
on the port.
z The port is must an access port.
Caution:
z If any of the protocols among GVRP, GMRP, IRF, NTDP, STP and 802.1x is
enabled for a port, you can not enable the VLAN-VPN function for the port.
z By default, STP and NTDP are enabled on a device. You can disable these two
protocols using the stp disable and undo ntdp enable commands.
z If there is a port enabled with fabric function on a device, you cannot enable
VLAN-VPAN function for this port or for any other port on this device.
1.2.2 Configuration procedure
Table 1-2 Configure the VLAN-VPN function for a port
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable the
VLAN-VPN
function on the port
vlan-vpn enable
Required
By default, the VLAN-VPN
function is disabled on a port.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English