Huawei Quidway S3900 Series User Manual

Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 RIP Configuration
Huawei Technologies Proprietary
3-4
3.3 Basic RIP Configuration
3.3.1 Configuration Prerequisites
Before configuring basic RIP functions, perform the following tasks:
z Configuring the link layer protocol
z Configuring the network layer addresses of interfaces so that adjacent nodes are
reachable to each other at the network layer
3.3.2 Configuring Basic RIP Functions
I. Enabling RIP globally and on the interface of a specified network segment
Table 3-2 Enable RIP globally and on the interface of a specified network segment
Operation Command Description
Enter system view
system-view
—
Enable RIP globally and
enter RIP view
rip
Required
Enable RIP on the
interface of a specified
network segment
network network-address
Required
By default, RIP is disabled
on any interface.
 Note:
z RIP can be enabled on an interface only after it has been enabled globally.
z RIP operates on the interface of a network segment only when it is enabled on the
interface. When RIP is disabled on an interface, it does not operate on the
interface, that is, it neither receives/sends routes on the interface nor forwards its
interface route. Therefore, after RIP is enabled globally, you must also specify its
operating network segments to enable it on the corresponding interfaces.
z The network 0.0.0.0 command is used to enable RIP on all interfaces.
II. Setting the RIP operating status on an interface
Table 3-3 Setting the RIP operating status on an interface
Operation Command Description
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English