Operation Manual – PoE & PoE Profile
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 PoE Configuration
1-3
Operation Description Related section
Set PoE management mode and
PoE priority of a port
Optional
Section
1.5 Setting PoE
Management Mode and
PoE Priority of a Port
Set the PoE mode on a port Optional
Section
1.6 Setting the
PoE Mode on a Port
Configure the PD compatibility
detection feature
Optional
Section
1.7 Configuring
the PD Compatibility
Detection Feature
Configure PoE over-temperature
protection on the switch
Optional
Section
1.8 Configuring
PoE Over-Temperature
Protection on the Switch
Upgrade the PSE processing
software online
Optional
Section
1.9 Upgrading
the PSE Processing
Software Online
1.3 Enabling the PoE Feature on a Port
Table 1-2 Enable the PoE feature on a port
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Enable the PoE feature on
the port
poe enable
Required
By default, the PoE
feature is disabled
on a port
1.4 Setting the Maximum Output Power on a Port
The maximum power that can be supplied by a PoE-enabled S3900 switch to its
PD is 15400 mW. In practice, you can set the maximum power on a port
depending on the actual power of the PD, in the range of 1000 to 15400 mW and in
the granularity of 100 mW.
Table 1-3 Set the maximum output power on a port
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—