Huawei Quidway S3900 Series User Manual

Operation Manual - QoS&QoS Profile
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 QoS Configuration
Huawei Technologies Proprietary
1-22
z Redirect all the traffic from the 10.1.1.1/24 network segment to Ethernet1/0/7
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] acl number 2000
[Quidway-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Quidway-acl-basic-2000] quit
[Quidway] interface Ethernet1/0/1
[Quidway-Ethernet1/0/1] traffic-redirect inbound ip-group 2000 interface
Ethernet1/0/7
1.10 Configuring Queue-scheduling
Refer to 1.1.11 Queue Scheduling for the introduction to queue scheduling.
1.10.1 Configuration Prerequisites
The queue-scheduling algorithm is specified: which queues adopt the WFQ
queue-scheduling algorithm and which queues adopt the SP queue-scheduling
algorithm
1.10.2 Configuration Procedure
Table 1-14 Configure queue scheduling in system view
Operation Command Description
Enter system view
system-view
—
Configure the queue
scheduling mode
queue-scheduler
{ strict-priority | wfq
queue0-width queue1-width
queue2-width queue3-width
queue4-width queue5-width
queue6-width queue7-width
| wrr queue0-weight
queue1-weight
queue2-weight
queue3-weight
queue4-weight
queue5-weight
queue6-weight
queue7-weight }
Required
In WRR or WFQ mode, if
the weight value or
minimum bandwidth of one
or more queues is set to 0,
SP algorithm is used for
this or these queues
By default, all the outbound
queues on the port adopt
the WRR queue scheduling
algorithm and their default
weight values are
1:2:3:4:5:9:13:15
Display the
queue-scheduling
mode and related
parameters on the
switch
display queue-scheduler
Optional
You can execute the
display command in any
view

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English