Huawei Quidway S3900 Series - Pim-DM Configuration; Configuring Filtering Policies for Multicast Source;Group

Operation Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 7 PIM Configuration
Huawei Technologies Proprietary
7-13
Table 7-5 Clear the related PIM entries
Operation Command Description
Clear the PIM route
entries
reset pim routing-table
{ all | { group-address
[ mask group-mask |
mask-length
group-mask-length ] |
source-address [ mask
source-mask |
mask-length
source-mask-length ] |
{ incoming-interface
{ interface-type
interface-number |
null } } } * }
Perform the configuration
in user view.
Clear PIM neighbors
reset pim neighbor { all |
{ neighbor-address |
interface interface-type
interface-number } * }
Perform the configuration
in user view.
7.3 PIM-DM Configuration
Perform the following configuration to configure PIM-DM. When the router runs in
PIM-DM domain, you are recommended to enable PIM-DM on all the interfaces of
non-boarder routers.
7.3.1 Configuring Filtering Policies for Multicast Source/Group
Table 7-6 Configure filtering policies for multicast source/group
Operation Command Description
Enter system view system-view
—
Enable the multicast
routing protocol
multicast
routing-enable
Required
Enter PIM view
pim
—
Perform source/group
filter on the received
multicast packets
source-policy
acl-number
Optional
You can configure to filter
the IP addresses of some
multicast groups in ACL.