Operation Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
Huawei Technologies Proprietary
1-25
Caution:
z The authentication response sent from the RADIUS server to the RADIUS client
carries the authorization information. Therefore, no separate authorization server
can be specified.
z In an actual network environment, you can either specify two RADIUS servers as
the primary and secondary authentication/authorization servers respectively, or
specify only one server as both the primary and secondary
authentication/authorization servers.
z The IP address and port number of the primary authentication server used by the
default RADIUS scheme "system" are 127.0.0.1 and 1645.
1.4.3 Configuring RADIUS Accounting Servers
Table 1-14 Configure RADIUS accounting server
Operation Command Description
Enter system view
system-view
—
Create a RADIUS
scheme and enter
its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS scheme
named "system" has already
been created in the system.
Set the IP address
and port number of
the primary
RADIUS
accounting server
primary accounting
ip-address
[ port-number ]
Required
By default, the IP address and
UDP port number of the primary
accounting server are 0.0.0.0 and
1813.
Set the IP address
and port number of
the secondary
RADIUS
accounting server
secondary accounting
ip-address
[ port-number ]
Optional
By default, the IP address and
UDP port number of the
secondary accounting server are
0.0.0.0 and 1813.
Enable
stop-accounting
packet buffering
stop-accounting-buffer
enable
Optional
By default, stop-accounting
packet buffering is enabled.
Set the maximum
number of
transmission
attempts of the
buffered
stop-accounting
packets.
retry stop-accounting
retry-times
Optional
By default, the system tries at
most 500 times to transmit a
buffered stop-accounting request.
To Next Page
Loading...
