Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 2 Static Route Configuration
Huawei Technologies Proprietary
2-5
[Switch B] ip route-static 0.0.0.0 0.0.0.0 1.1.4.1
# Configure the default gateway of Host C to 1.1.1.1.
[Switch C] ip route-static 1.1.1.0 255.255.255.0 1.1.1.1
Now, all the hosts/switches in the figure can interconnect with each other.
2.5 Troubleshooting a Static Route
Symptom: The switch is not configured with a dynamic routing protocol. Both the
physical status and the link layer protocol status of an interface are UP, but IP packets
cannot be normally forwarded on the interface.
Solution: Perform the following procedure.
Use the display ip routing-table protocol static command to view whether the
corresponding static route is correctly configured.
Use the display ip routing-table command to view whether the static route is valid.
To Next Page
Loading...
Need help?
General