Huawei Quidway S3900 Series User Manual

Operation Manual – Auto Detect
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 2 Auto Detect Implementation
Huawei Technologies Proprietary
2-1
Chapter 2 Auto Detect Implementation
2.1 Introduction
The results of auto detect operations (reachable or unreachable) can be used to
trigger other functions, such as:
z Static routing
z Virtual router redundancy protocol (VRRP)
z Interface backup
z Packet redirection
You can utilize a single detecting group simultaneously in multiple implementations
mentioned above.
 Note:
z Refer to the Routing Protocol chapter of this manual for information about static
routing.
z Refer to the VRRP chapter of this manual for information about VRRP.
2.2 Auto Detect Implementation in Static Routing
By binding a detecting group to a static route, you can control the validity of a static
route according to auto detect results as follows:
z Enable the static route when the result of the detecting group is reachable.
z Disable the static route when the result of the detecting group is unreachable.
2.2.1 Configuring the Auto Detect Function for a Static Route
 Note:
You need to create the detecting group before performing the following operations.
Table 2-1 Configure the auto detect function for a static route
Operation Command Description
Enter system view
system-view
—

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English