Huawei Quidway S3900 Series User Manual

Operation Manual – Cluster
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Cluste
r
Huawei Technologies Proprietary
1-10
Operation Command Description
Enable the cluster
function globally
cluster enable
Optional
By default, the cluster function
is enabled
1.2.7 Configuring Cluster Parameters
I. Configuring cluster parameters manually
Table 1-8 Configure cluster parameters manually
Operation Command Description
Enter system view
system-view
—
Specify the
management
VLAN
management-vlan vlan-id
This is to specify the
management VLAN on the
switch
Enter cluster view
cluster
—
Configure an IP
address pool for
the cluster
ip-pool
administrator-ip-address
{ ip-mask | ip-mask-length }
Required
Build a cluster
build name
Optional
The name argument is the
name to be assigned to the
cluster.
Configure a
multicast MAC
address for the
cluster
cluster-mac H-H-H
Optional
By default, the multicast MAC
address is 0180-C200-000A
Set the interval for
the management
device to send
multicast packets
cluster-mac syn-interval
time-interval
Optional
By default, the management
device sends a multicast
packet every minute.
Configure the
holdtime for a
switch
holdtime seconds
Optional
By default, the holdtime is 60
seconds
Set the interval to
send handshake
packets
timer interval
Optional
By default, the interval to send
handshake packets is 10
seconds
Quit cluster view
quit
—

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English