Huawei Quidway S3900 Series User Manual

Operation Manual – 802.1x
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 2 HABP Configuration
Huawei Technologies Proprietary
2-2
Operation Command Description
Enable HABP
habp enable
Required
HABP is enabled by default.
Configure the
current switch to
be an HABP server
habp server vlan vlan-id
Required
By default, a switch operates
as an HABP client after you
enable HABP on the switch,
and if you want to use the
switch as a management
switch, you must configure the
switch to be an HABP server.
Configure the
interval to send
HABP request
packets.
habp timer interval
Optional
The default interval for an
HABP server to send HABP
request packets is 20
seconds.
2.3 HABP Client Configuration
HABP clients reside on switches attached to HABP servers. After you enable HABP for
a switch, the switch operates as an HABP client by default. So you only need to enable
HABP on a switch to make it an HABP client.
Table 2-2 Configure an HABP client
Operation Command Description
Enter system view
system-view
—
Enable HABP
habp enable
Optional
HABP is enabled by default.
And a switch operates as an
HABP client after you enable
HABP for it.
2.4 Displaying HABP
After performing the above configuration, you can display and verify your HABP-related
configuration by execute the display command in any view.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English