Huawei Quidway S3900 Series - Configuring the Maximum Number of Ospf Equal-Cost Routes; Setting Ospf Route Priority

Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 4 OSPF Configuration
Huawei Technologies Proprietary
4-18
Operation Command Description
Configure the cost for sending
packets on an OSPF interface
ospf cost value
Optional
By default, OSPF
calculates the cost for
sending packets on an
interface according to
the current baud rate
on the interface. For a
VLAN interface on the
switch, this value is
fixed at 10.
4.6.5 Setting OSPF Route Priority
Since multiple dynamic routing protocols may be running on one router, the problem
of route sharing and selection between various routing protocols arises. The system
sets a priority for each routing protocol (which you can change manually), and when
more than one route to the same destination is discovered by different protocols, the
route with the highest priority will take preference over other routes.
Table 4-11 Set OSPF route priority
Operation Command Description
Enter system view
system-view
—
Enter OSPF view
ospf [ process-id
[ router-id router-id ] ]
Required
Set OSPF route priority preference [ ase ] value
Optional
By default, the OSPF
route priority is 10 and the
priority of OSPF ASE is
150.
4.6.6 Configuring the Maximum Number of OSPF Equal-Cost Routes
Table 4-12 Configure the maximum number of OSPF equal-cost routes
Operation Command Description
Enter system view
system-view
—
Enter OSPF view
ospf [ process-id
[ router-id router-id ] ]
Required
Configure the maximum number
of OSPF equal-cost routes
multi-path-number value
Optional