Huawei Technologies Proprietary
1-8
Operation Command Description
Define an
information source
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap
| debug } * { level severity |
state state } * ]
Required
Set the format of
the time stamp to
be sent to the log
host
info-center timestamp
loghost { date |
no-year-date | none }
Optional
Note:
z After the switches form a fabric, you can use the info-center switch-on command to
enable the information output for the switch to make the log, debugging and trap
information of each switch in the fabric synchronous. Each switch sends its own
information to other switches in the fabric and receives information sent by other
switches at the same time to update the information on itself. In this way, the switch
ensures the synchronization of log, debugging and trap information in the whole
fabric.
z To view the debugging information of specific modules, you need to set the
information type as debug in the info-center source command, and enable
debugging for corresponding modules through the debugging command.
1.2.3 Enabling Information Output to the Console
Table 1-6 lists the related configurations on the switch.
Table 1-6 Enable information output to the console
Operation Command Description
Enter system view
system-view
—
Enable the
information center
info-center enable
Optional
By default, the information
center is enabled.
Enable information
output to the
console
info-center console
channel { channel-number |
channel-name }
Required
By default, the switch uses
information channel 0 to
output log/debugging/trap
information to the console.