Huawei Quidway S3900 Series User Manual

Operation Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 8 MSDP Configuration
Huawei Technologies Proprietary
8-10
Operation Command Description
Configure the RP address
to be carried in SA
messages
originating-rp
interface-type
interface-number
Required
By default, the RP
address in SA messages
is the RP address
configured by PIM.
 Note:
In Anycast RP application, C-BSR and C-RP must be configured on different devices or
ports.
8.3.4 Configuring an MSDP Mesh Group
Configure a mesh group name on all the peers that will become members of the MSDP
mesh group, so that the peers are fully connected with one another in the mesh group.
Table 8-5 Configure an MSDP mesh group
Operation Command Description
Enter system view
system-view
—
Enter MSDP view
msdp
—
Add an MSDP peer in a
mesh group
peer peer-address
mesh-group name
Required
This command must be
configured on all the
peers, so you must
configure this command
for multiple times.
 Note:
z Before you configure an MSDP mesh group, make sure the routers must be fully
connected with one another.
z The same group name must be configured on all the peers.
z If you add the same MSDP peer into multiple mesh groups, only the latest
configuration takes effect.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English