Huawei Quidway S3900 Series - Configuring Interaction for the Cluster; Configuring Nm Interface for the Cluster

Operation Manual – Cluster
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Cluste
r
Huawei Technologies Proprietary
1-11
II. Building a cluster automatically
Table 1-9 Enable the cluster function automatically
Operation Command Description
Enter system view
system-view
—
Enter cluster view
cluster
—
Configure the rang
e of the IP
addresses of the
cluster
ip-pool
administrator-ip-address
{ ip-mask | ip-mask-length }
Required
Build a cluster
automatically
auto-build [ recover ]
Optional
You can build clusters
according to corresponding
prompts
1.2.8 Configuring Interaction for the Cluster
Table 1-10 Configure interaction for the cluster
Operation Command Description
Enter system view
system-view
—
Enter cluster view
cluster
Required
Configure the
public FTP server
for the cluster
ftp-server ip-address
Optional
Configure the
TFTP server for the
cluster
tftp-server ip-address
Optional
Configure the
logging host for the
cluster
logging-host ip-address
Optional
Configure the
SNMP host for the
cluster
snmp-host ip-address
Optional
1.2.9 Configuring NM Interface for the Cluster
I. Configuration prerequisites
z The switches in the cluster are connected correctly;
z The internal server is correctly connected to the management switch.