Huawei Quidway S3900 Series User Manual

Operation Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Port Basic Configuration
Huawei Technologies Proprietary
1-4
An access port can only be added to one VLAN, while hybrid and trunk ports can be
added to multiple VLANs.
 Note:
The access ports or hybrid ports must be added to an existing VLAN.
1.2 Ethernet Port Configuration
1.2.1 Initially Configuring a Port
Table 1-3 Initially configure a port
Operation Command Remarks
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable the Ethernet
port
undo shutdown
Optional
By default, the port is
enabled.
Use the shutdown
command to disable the port.
Set the description of
the Ethernet port
description text
Optional
By default, no description is
defined for the port.
Set the duplex mode of
the Ethernet port
duplex { auto | full |
half }
Optional
By default, the duplex mode
of the port is auto
(auto-negotiation).
Set the speed of the
Ethernet port
speed { 10 | 100 | 1000 |
auto }
Optional
By default, the speed of the
port is auto
(auto-negotiation).
Set the medium
dependent interface
(MDI) attribute of the
Ethernet port
mdi { across | auto |
normal }
Optional
Be default, the MDI attribute
of the port is auto.
Allow jumbo frames
that are not larger than
9216 bytes to pass
through the Ethernet
port
jumboframe enable
Optional
By default, jumbo frames that
are not larger than 9216
bytes are allowed to pass
through the port.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English