Huawei Quidway S3900 Series - Displaying and Maintaining a Cluster

Operation Manual – Cluster
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Cluste
r
Huawei Technologies Proprietary
1-15
Operation Command Description
Remove a member
device from the
cluster
delete-member
member-num
Optional
Reboot a specified
member device
reboot member
{ member-num |
mac-address H-H-H }
[ eraseflash ]
Optional
Return to system
view
quit
—
Return to user view
quit
—
Switch between
the management
device view and a
member device
view
cluster switch-to
{ member-number |
mac-address H-H-H |
administrator }
Optional
Switch between the
management device view and
the member device view
1.5 Displaying and Maintaining a Cluster
After the configuration above, you can execute the display command to display the
running status after the cluster configuration. You can verify the configuration effect
through checking the displayed information.
Table 1-17 Display and maintain cluster configurations
Operation Command Description
Display the global
NDP configuration
(including the
interval to send
NDP packets and
the holdtime)
display ndp
Display the
information about
the neighbors
discovered by NDP
and connected to
specified ports
display ndp interface
port-list
Display the global
NTDP information
display ntdp
Display device
information
collected through
NTDP
display ntdp device-list
[ verbose ]
Optional
You can execute the display
command in any view