Huawei Quidway S3900 Series User Manual

Operation Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Port Basic Configuration
Huawei Technologies Proprietary
1-12
Table 1-15 Display basic port configuration
Operation Command Remarks
Display port
configuration
information
display interface
[ interface-type | interface-type
interface-number ]
Display information
about a specified
optical port
display
transceiver-information
interface interface-type
interface-number
Display the
enable/disable status
of port loopback
detection
display loopback-detection
Display brief
information about port
configuration
display brief interface
[ interface-type
interface-number ] [ | { begin |
include | exclude } string ]
Display the hybrid or
trunk ports
display port { hybrid | trunk }
You can execute the
display commands in
any view.
Display port
information about a
specified unit
display unit unit-id interface
Clear port statistics
reset counters interface
[ interface-type | interface-type
interface-number ]
You can execute the
reset command in user
view.
After 802.1x is enabled
on a port, clearing the
statistics on the port will
not work.
1.3 Ethernet Port Configuration Example
I. Network requirements
z Switch A and Switch B are connected to each other through two trunk port
(Ethernet1/0/1).
z Configure the default VLAN ID of both Ethernet1/0/1 to 100.
z Allow the packets of VLAN 2, VLAN 6 through VLAN 50 and VLAN 100 to pass
both Ethernet1/0/1.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English